Verification Test
WARNING: This page is about a different car, the 1999 Dodge Intrepid and 1999 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Reconnect all previously disconnected components and wiring. If Body Control Module (BCM) has not been replaced, go to next step. If BCM has been replaced, use DRB (scan tool) to program all Remote Keyless Entry (RKE) transmitters, recalibrate A/C-heater system doors, and program other options as necessary.
- If A/C-heater system has been repaired or battery has been disconnected, A/C-heater door actuators must be calibrated. Start engine and use scan tool to calibrate door actuators. DO NOT allow vehicle to move during door actuator calibration. Turn engine off and go to next step.
- Turn ignition on. Using scan tool, erase Diagnostic Trouble Codes (DTCs). Turn ignition off and wait at least 5 seconds. Turn ignition on (engine off) and fully operate repaired system to verify correct operation. If system operates properly, go to next step. If system does not operate properly, go to TEST 1A: IDENTIFYING A/C-HEATER SYSTEM PROBLEMS .
- If A/C-heater system operates properly, use scan tool to check for other BCM DTCs. If any BCM DTCs are present, go to TEST 1B: IDENTIFYING A/C-HEATER DIAGNOSTIC TROUBLE CODES . If no BCM DTCs are present and original DTC cannot be duplicated, repair is complete.