LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1998 >> Sebring JXi, 2.5 H >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer (Except Coupe) >> Body Control Computer Tests >> Test VER-1A - Verification Procedure

Test VER-1A - Verification Procedure

  1. Reconnect all previously disconnected components and wiring. If battery or BCM has been disconnected, or any work has been performed on A/C system, A/C mode doors must be calibrated. Start engine and use scan tool to calibrate A/C mode doors. Do not allow vehicle to move during calibration. When calibration is complete, turn engine off and ignition on. Use scan tool to erase trouble codes.
  2. Turn ignition off and wait at least 5 seconds and then turn ignition on (engine off). Operate system that was malfunctioning to verify correct operation. If system operates properly, repair is complete. If system does not operate properly, go to SYMPTOM ID TEST 1A  .
scientia non olet · About LEMON Manuals