LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1998 >> Sebring JXi, 2.4 X >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments - 2.4L Engine >> Throttle Position Sensor >> 4-Cylinder Throttle Position Sensor

4-Cylinder Throttle Position Sensor

NOTE: Throttle Position (TP) sensor is nonadjustable. Use following procedure to check TP sensor calibration. For complete testing of TP sensor and wiring circuit, see appropriate TESTS W/CODES article.
  1. Remove components for access to electrical connector at TP sensor mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT start engine.
  2. Using Digital Volt-Ohmmeter (DVOM), check voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be within specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS table.
  3. Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS table. Replace TP sensor if voltage is not within specification.
4-CYLINDER TP SENSOR SPECIFICATIONS

Application & Throttle Opening Specification
Sebring Convertible (1)
At Idle Greater Than .60 Volt
At Full Throttle Less Than 4.50 Volts
(1) Measure voltage at center terminal on TP sensor with ignition on. Voltage should smoothly increase when moving throttle from idle to full throttle.
scientia non olet · About LEMON Manuals