Power Mirror Motor
Using Trim Stick (C-4755), remove power mirror switch from mounting. Disconnect wire connector. Using 2 jumper wires, connect one to a 12-volt source and the other to a good ground. If tests do not agree with POWER MIRROR MOTOR TEST
table, check for open or shorted circuit, or replace mirror assembly as necessary. See Fig 1
.
POWER MIRROR MOTOR TEST
| Apply 12 Volts To Pin No. |
Ground Pin No. |
Mirror Operation (Right) |
Mirror Operation (Left) |
| Switch Connector |
| 12 |
6 |
Up |
--- |
| 13 |
1 |
--- |
Up |
| 6 |
12 |
Down |
--- |
| 1 |
13 |
--- |
Down |
| 6 |
7 |
Right |
--- |
| 1 |
8 |
--- |
Right |
| 7 |
6 |
Left |
--- |
| 8 |
1 |
--- |
Left |
| Door Connector |
| 6 |
2 |
Up |
Up |
| 2 |
6 |
Down |
Down |
| 2 |
5 |
Right |
Right |
| 5 |
2 |
Left |
Left |
| 1 |
3 |
|
|
Courtesy of CHRYSLER CORP.