Connector Identification
NOTE:
For terminal identification of body control system connectors use illustrations. See Fig 1
-Fig 17
. Connector terminal numbers are molded into connectors. If connector terminal identification differs from that shown in figure, use wire colors to ensure correct circuit is being tested.
CONNECTOR IDENTIFICATION DIRECTORY
| Connector | See |
|---|---|
| Body Control Module 10-Pin | Fig. Fig 1 |
| Body Control Module 14-Pin | Fig. Fig 2 |
| Body Control Module 20-Pin | Fig. Fig 3 |
| Body Control Module 22-Pin | Fig. Fig 4 |
| Compass Mini-Trip Computer | Fig. Fig 5 |
| Courtesy Light Relay | Fig. Fig 6 |
| Data Link (DLC) | Fig. Fig 7 |
| Instrument Cluster | Fig. Fig 8 |
| Ignition Switch | Fig. Fig 9 |
| Junction Block 6-Pin | Fig. Fig 10 |
| Junction Block (Typical - NS Body Shown) | Fig. Fig 11 |
| Multifunction Switch 10-Pin Connector Terminals | Fig. Fig 12 |
| Multifunction Switch 7-Pin Connector Terminals | Fig. Fig 13 |
| Powertrain Control Module Connectors | Fig. Fig 14 |
| Relay Connector | Fig. Fig 15 |
| Transmission Control Module Connector | Fig. Fig 16 |
| Wiper Motor | Fig. Fig 17 |