Front Wheel Speed Sensor (WSS): Installation

1. Ensure front WSS hole in steering knuckle is clean. Apply light coat of high-temperature multipurpose grease on sensor-to-steering knuckle contact areas.
2. Install front WSS in steering knuckle. Ensure WSS is fully seated. Install and tighten front WSS-to-steering knuckle bolt to specification. See TORQUE SPECIFICATIONS  .
3. Front WSS air gap should be .020-.065" (.52-1.64 mm). Front WSS air gap is non-adjustable. To install remaining components, reverse removal procedure. Ensure locking tab on electrical connector is securely locked in place and wiring harness is properly routed. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Removing Grommet Retaining Clip For Front Wheel Speed Sensor

Courtesy of CHRYSLER CORP.