Test 74A - Gauges Do Not Go To Zero With Key Off

WARNING: This page is about a different car, the 1996 Eagle Vision, 1996 Dodge Intrepid, 1996 Chrysler New Yorker, 1996 Chrysler LHS, and 1996 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER section in this article. Perform TEST VER-1 VERIFICATION TEST after each repair.

CAUTION: Always turn ignition off prior to disconnecting any module connector.

Turn ignition off. Disconnect instrument cluster Black connector. Using scan tool in voltmeter mode, check voltage on instrument cluster Black connector terminal No. 8 (Pink/Red wire). If voltage is 10 volts or less, repair open Pink/Red wire. If voltage is more than 10 volts, replace instrument cluster.