Test 58B - Instrument Cluster Printed Circuit Board
WARNING: This page is about a different car, the 1996 Eagle Vision, 1996 Dodge Intrepid, 1996 Chrysler New Yorker, 1996 Chrysler LHS, and 1996 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Using scan tool, stop actuation test. Turn ignition off. Disconnect instrument cluster. Remove and inspect inoperative lamp. Replace lamp if necessary. If lamp is okay, go to next step.
- Inspect instrument cluster printed circuit board. Replace printed circuit board if necessary. If printed circuit board is okay, repair or replace instrument cluster. See INSTRUMENT PANEL article.