LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1997 >> Cirrus LX, 2.5 H >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer (Except Coupe) >> Body Control Computer Tests >> VTSS Test 14A - DECKLID Release Inoperative From RKE

VTSS Test 14A - DECKLID Release Inoperative From RKE

NOTE: Perform VTSS TEST 1A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-1A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Disconnect BCM 14-pin connector located at junction block. See Figure in CHIME TEST 3A. Using external voltmeter, measure voltage between ground and terminal No. 3 (Brown/Light Blue wire) on 20-pin connector. If voltage is greater than 6 volts, replace Body Control Module (BCM). If voltage is 6 volts or less, repair open Brown/Light Blue wire.

scientia non olet · About LEMON Manuals