LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1996 >> Sebring LX, 2.5 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls - Tests W/Codes - 2.0L) >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> Using Scan Tool

Using Scan Tool

WARNING: This page is about a different variant/trim than selected.
  1. Ensure battery is fully charged. Turn ignition off. Connect scan tool to Data Link Connector (DLC). Two connections required. One at 12-pin DLC, and another at 16-pin DLC. See DATA LINK CONNECTOR (DLC) table for connector location. See Fig 1.
    DATA LINK CONNECTOR (DLC) LOCATION

    Application DLC Location
    Avenger & Sebring 2.0L Base Of Steering Column
    Fig 1: Data Link Connectors (DLCs) Location
    G95D12677Courtesy of CHRYSLER CORP.
  2. Turn ignition on. Using scan tool manufacturer's instructions, record all DTCs displayed on scan tool. Using all DTCs obtained, proceed to SELF-DIAGNOSTIC TESTS . Once all repairs are made, ensure DTCs are cleared from PCM. See CLEARING DIAGNOSTIC TROUBLE CODES.
scientia non olet · About LEMON Manuals