Section 8 (Engine Controls - System & Component Testing - 2.4L): Introduction

WARNING: This page is about a different variant/trim than selected.

Before testing separate components or systems, perform procedures in the BASIC TESTING - 2.4L article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in TESTS W/CODES - 2.4L article.

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.