Test 74A - Gauges Do Not Go To Zero With Key Off
WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform TEST 54A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Turn ignition off. Disconnect instrument cluster Black connector. Using scan tool in voltmeter mode, measure voltage at terminal No. 8 (Pink/Red wire) on instrument cluster Black connector. If voltage is 10 volts or less, repair open Pink/Red wire. If voltage is more than 10 volts, replace instrument cluster.