Service Precautions

Before proceeding with system diagnosis, following precautions must be followed:

• When using SELF-DIAGNOSTIC TESTS for diagnosis, DO NOT  skip any steps, or incorrect diagnosis may result. Always perform indicated verification procedure after repairs are made.
• When using a jumper wire, ensure either jumper wire or circuit is fuse-protected.
• Before disconnecting connector from any control module, ensure ignition is off before removing connector.
• When checking voltage or continuity at any control module, probe connector for control module from pin side. DO NOT  backprobe connector or probe wires through the insulation.
• DO NOT  cause short circuits when performing electrical tests. This will set additional Diagnostic Trouble Codes (DTCs), making diagnosis of original problem more difficult.
• Use specific test equipment as specified when performing electrical tests.