LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1996 >> Cirrus LXi, 2.5 H >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Diagnostic Charts >> Windshield Wiper Test 2F - Wipers Not Working At All

Windshield Wiper Test 2F - Wipers Not Working At All

NOTE: Perform VTSS TEST 1A before proceeding with this test. For connector terminal identification and wiring diagrams, see CONNECTOR IDENTIFICATION section in this article. Perform VERIFICATION TEST VER-1A after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Remove and inspect fuse No. 15 (10-amp) in junction block. See Figure in CHIME TEST 3A. If fuse is open, go to WINDSHIELD WIPER TEST 2G. If fuse is okay, go to next step.
  2. Using external voltmeter, check voltage on cavity No. 28 (Black/White wire) for fuse No. 15. See Figure in CHIME TEST 3A. If voltage is 10 volts or less, repair open in Black/White wire between ignition switch and junction block. If voltage is more than 10 volts, repair open in Dark Blue/Gray wire between junction block and intermittent wiper relay.
scientia non olet · About LEMON Manuals