All Doors Will Not Unlock Using Transmitter (1996 Models)
- Unlock driver's door. Using voltmeter, backprobe BCM 20-pin connector. Check for a voltage pulse at terminal No. 4, while pressing UNLOCK button on transmitter. See Fig 1
. BCM is located on junction block, behind lower left corner of instrument panel. If there is no voltage pulse, replace BCM. See REMOVAL & INSTALLATION. If voltage pulse is present, repair circuit between BCM and driver's door lock motor. See appropriate wiring diagram in WIRING DIAGRAMS.
- Check for voltage pulse at terminals No. 1, 2 and 3 while pressing transmitter UNLOCK button twice within 5 second interval. If there is no voltage pulse, replace BCM. If voltage pulse is present, repair suspect circuit between appropriate BCM terminal and suspect door lock motor.
Courtesy of CHRYSLER CORP.