Test 7C - Short To Battery
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
section at the end of this article.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using scan tool in voltmeter mode, check voltage at Controller Anti-Lock Brake (CAB) module connector terminal No. 41, pedal travel sensor return circuit (Red/Black wire).
- If voltage is more than 10 volts, repair short to voltage in Red/Black wire and replace CAB module. Perform TEST VER-1. If voltage is less than 10 volts, replace CAB module. Perform TEST VER-1.
NOTE:
Test procedures skip from TEST 7C to TEST 7E. No test procedures have been omitted.