LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - 2.0L & 2.4L >> Fuel System >> Fuel Injector Resistors >> Talon Turbo

Talon Turbo

  1. Disconnect fuel injector resistors connector. Fuel injector resistors connector is located in rear of engine compartment. See Fig 1. Using a DVOM, measure resistance between fuel injector resistors connector terminals No. 1 and 3, No. 4 and 3, No. 5 and 3, and No. 6 and 3. See Fig 2.
  2. Resistance between specified terminals should be 5.5-6.5 ohms at 68°F (20°C). If resistance is not within specification, replace fuel injector resistors. If resistance is within specification, fuel injector resistors are okay.
Fig 1: Locating Fuel Injector Resistors (Talon Turbo)
G95I13654Courtesy of CHRYSLER CORP.
Fig 2: Testing Fuel Injector Resistors (Talon Turbo)
G95H13653Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals