LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis >> Engine Mechanical >> Engine Cooling Fan >> Component Testing >> Radiator & Condenser Fan Relay

Radiator & Condenser Fan Relay

  1. Remove relay from PDC, located in front left strut tower. Using an ohmmeter, ensure continuity exists between terminals No. 1 and 3, and does not exist between terminals No. 4 and 5. See IGNITION SWITCH CIRCUIT WIRE ID  table.
  2. Connect battery voltage to terminal No. 1 and ground terminal No. 3. Ensure continuity exists between terminals No. 4 and 5. If continuity is not as specified, replace relay.
    IGNITION SWITCH CIRCUIT WIRE ID

    Application Wire Color
    Avenger, Talon & Sebring Blue/Red
    PCM PIN IDENTIFICATION

    Application Pin No.
    Avenger, Sebring & Talon 31
    Fig 1: PCM 60-Pin Connector Terminals
    G90G10161Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals