Antilock Warning Lamp Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.

Turn ignition off. Disconnect CAB 60-pin connector. See Figure. Inspect, clean or repair connector as necessary. Disconnect ABS relay. Inspect, clean or repair connector as necessary. Using scan tool in voltmeter mode, check voltage on CAB connector terminal No. 15 (Light Green/Orange wire). If reading is more than 9 volts, replace CAB. Perform TEST VER-1A. If reading is less than 9 volts, repair open in Light Green/Orange wire. Perform TEST VER-1A.