Starter Relay Test
WARNING: This page is about a different car, the 1995 Chrysler New Yorker and 1995 Chrysler LHS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform solenoid test before testing starter relay.
Locate and remove starter relay. Starter relay is located within Power Distribution Center (PDC). See Figure . Connect 12-volt power source to starter relay terminal No. 86 and ground terminal No. 85. See Fig 1 . Using ohmmeter, check continuity across starter relay terminals No. 30 and 87. If continuity is not present, replace starter relay.