LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Cirrus LXi >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 7B >> Abs Warning Lamp Circuit

Abs Warning Lamp Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.
  1. Turn ignition off. Turn ignition on. Using scan tool, check ABS warning light status. If scan tool displays ABS WARNING LAMP OUTPUT = ON, go to TEST 20A. If scan tool does not display ABS WARNING LAMP OUTPUT = ON, go to next step.
  2. Turn ignition off. Disconnect Controller Anti-Lock Brake (CAB) 60-pin connector. Disconnect relay box 10-pin connector. Inspect, clean and repair connectors as necessary. Perform TEST VER-1A. If connectors are okay, turn ignition on. Using scan tool in voltmeter mode, check voltage on CAB connector terminal No. 15 (Light Green/Orange wire). If reading is more than 10 volts, replace relay box. Perform TEST VER-1A. If reading is less than 10 volts, repair short to ground in Light Green/Orange or Light Green/Brown wire. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals