Abs Relay Ground Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.

Turn ignition off. Disconnect relay box 10-pin connector. Inspect, clean and repair connector as necessary. Perform TEST VER-1A. If connector is okay, use scan tool in voltmeter mode to check voltage on relay box 10-pin connector terminal No. 2 (Brown/Black wire). If reading is more than 5 volts, repair short to power in Brown/Black wire. Perform TEST VER-1A. If reading is less than 5 volts, replace relay box. Perform TEST VER-1A.