Test 41C - Repairing Door Lock Problem
NOTE:
For connector terminal identification, see CONNECTOR
IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS
. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
Gain access to right door lock switch connector. Put DRB in voltmeter mode. With door lock switch connector connected, measure voltage at switch connector terminal No. 3 (Red wire). If voltage is less than 10 volts, repair open Red wire. If voltage is more than 10 volts, replace both door lock switches.