Verification Procedure VER-3

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If another fault was read previously and not corrected, return to TEST DR-1A  and follow path specified by other fault. If SBEC was replaced, perform following:

1. If vehicle is equipped with factory theft alarm, start vehicle at least 20 times so alarm system may be activated when desired. Connect DRB-II to engine diagnostic connector, and erase faults. Disconnect DRB-II. Ensure other faults do not exist.
2. If vehicle is equipped with A/C, turn A/C on. Set blower to low speed. On all models, drive vehicle for at least 5 minutes and attain a speed of at least 40 MPH. Ensure transmission shifts through all gears.
3. Upon completion of road test, turn engine off. Restart engine, and let it idle for at least 2 minutes. Turn engine off. Connect DRB-II to engine diagnostic connector.
4. Read all fault messages. If repaired fault has reset, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs). Return to TEST DR-1A  if necessary and follow path specified by other fault. If other faults do not exist, repair is now complete.