Engine Assembly: Remove, Install, and Overhaul
WARNING: This page is about the LeBaron Base, 2D Convertible, 2.5 J, which is a different variant/trim than selected.
Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters.
Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.5L Eng,Automatic Trans,Normally Aspirated, w/Air Cond | 21.9 | A | ||
| 2.5L Eng,Automatic Trans,Normally Aspirated, w/o Air Cond | 21.4 | A | ||
| 2.5L Eng,Automatic Trans,Turbocharger, w/Air Cond | 22.5 | A | ||
| 2.5L Eng,Automatic Trans,Turbocharger, w/o Air Cond | 22.0 | A | ||
| Additional Procedure: ENGINE ASSEMBLY: Remove, Install, and Overhaul: | ||||
| Where Pwr Strg interferes add | 0.3 | A | ||