LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1992 >> Imperial >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 3 - Automatic Door Locks W/Keyless Entry System >> TEST 3C - Automatic Door Locks With Remote Keyless Entry

TEST 3C - Automatic Door Locks With Remote Keyless Entry

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
  1. Using DRB-II, stop door lock actuation test. Turn ignition switch to OFF position. Gain access to power door lock relays. Relays are located behind right side of glove box. See Figure. Remove door unlock relay. Check connector condition, and clean or repair connector as necessary.
  2. Put DRB-II in ohmmeter mode. Probe Black wire of door unlock relay connector. If resistance is more than 5 ohms, repair open Black wire. Perform VERIFICATION TEST VER-1 . If resistance is less than 5 ohms, probe Pink/Black wire of unlock relay connector.
  3. If resistance is more than 5 ohms, repair open Pink/Black wire. Perform VERIFICATION TEST VER-1 . If resistance is less than 5 ohms, replace door unlock relay. Perform VERIFICATION TEST VER-1 .
scientia non olet · About LEMON Manuals