Bench Seat

Disconnect power seat switch. Connect a jumper wire between Red wire terminal and either Red/Dark Green or Yellow/Dark Green wire terminals in rear of switch connector. See Fig 4 .

Fig 1: Switch Connector Door Mounted (LeBaron)
Courtesy of CHRYSLER MOTORS.

Fig 2: Switch Connector Door/Seat Mounted
Courtesy of CHRYSLER MOTORS.

Fig 3: Switch Connector Console Mounted (Daytona)
Courtesy of CHRYSLER MOTORS.

Fig 4: Bench Seat Switch Connector (FWD Models)
Courtesy of CHRYSLER MOTORS.
Connect second jumper wire between Black wire terminal and open connection in rear of connector. If motor does not operate, reverse jumper wires in rear of connector. If motor will not operate, inspect wiring harness. If wiring is okay, replace 3-motor assembly.