Automatic Stop Check
- Connect 12 volts one terminal and ground other terminal. Disconnect jumper wires during operation to stop motor. See AUTOMATIC STOP OPERATION TERMINAL NUMBERS
for terminals and model application.
- Using a jumper wire, connect 2 terminals together. Connect 12 volts to other terminal and ground wiper motor bracket. Ensure motor runs, then stops. See JUMPER WIRE/BATTERY POSITIVE TERMINAL NUMBERS - REAR
. See Figure
.
AUTOMATIC STOP OPERATION TERMINAL NUMBERS
| Model |
Voltage (-) Terminal No. |
Voltage (+) Terminal No. |
| Colt |
4 |
1 |
| Colt Vista |
1 |
3 |
| Conquest |
4 |
3 |
| Raider |
3 |
1 |
JUMPER WIRE/BATTERY POSITIVE TERMINAL NUMBERS - REAR
| Model |
Jumper Wire Terminals No. |
Voltage (+) Terminal No. |
| Colt |
3-4 |
1 |
| Colt Vista |
1-2 |
3 |
| Conquest |
1-4 |
3 |
| Raider |
2-3 |
1 |