LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1987 >> Conquest 2.6 N >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel - Electronic >> Testing >> Pulse Generator

Pulse Generator

  1. Remove pulse generator from vehicle. Apply 12 volts to terminal No. 1 (positive) and ground terminal No. 3 (negative). Also connect a 3000-10,000 ohm resistor in-line between terminal No. 2 and power supply to terminal No. 1. See Fig 1 .
  2. Install a voltmeter between terminals No. 2 and No. 3. Rotate pulse generator and verify that one revolution equals 4 meter deflections.
Fig 1: Hook-up For Pulse Generator Testing
G64918Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals