Low-Reverse Band (Rear)

Low reverse band adjusting screw is located on rear servo lever. Transmission oil pan must be removed to provide access to band adjusting screw. See Fig 1.

Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location

Courtesy of CHRYSLER LLC

1. Drain transmission and remove oil pan. Loosen band adjusting screw lock nut about 5 turns. Ensure adjusting screw turns freely in case. Tighten adjusting screw to 41 INCH lbs. (4.6 N.m).
2. Back off adjusting screw specified number of turns given in LOW-REVERSE BAND ADJUSTMENT  table. Hold in this position and tighten lock nut, Install oil pan and fill transmission with fluid.