LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1985 >> Laser Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Testing >> Cruise Control Switch

Cruise Control Switch

  1. Disconnect 4-wire connector at steering column. Connect a 12-volt positive source to Yellow wire terminal in connector going to cruise control switch. With switch in "ON" position, connect a test lamp between the Brown/Red (FWD) or Yellow (RWD) terminal and ground. Lamp should light and then go out when the speed set button is depressed.
  2. Move test lamp lead to Dark Blue/White (FWD) or Dark Blue (RWD) wire terminal. Lamp should light with switch in "ON" position. Lamp should go out when switch is moved to "OFF" position. With switch in "ON" position, move test lamp lead to White/Red (FWD) or White (RWD) wire terminal.
  3. Lamp should light when speed set button is depressed or switch moved to "RESUME" position. If switch does not operate properly in all tests, replace it. If switch operates properly in all tests, complete brake switch and servo unit tests.
scientia non olet · About LEMON Manuals