LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1985 >> Laser Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Fuel Injection System - Multi-Point >> Removal & Installation >> Throttle Position Sensor >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable and 6-way throttle body connector. Remove 2 screws mounting throttle position sensor to throttle body. Unclip wiring clip from convoluted tube and remove mounting bracket.
  2. Lift throttle position sensor off throttle shaft and remove "O" ring. Pull 3 TPS wires from the convoluted tubing.
  3. Look inside the 6-way throttle body connector and lift locking tab with a small screwdriver for each TPS wire blade terminal. Remove each TPS wire blade terminal. Remove each blade from connector. To install, reverse removal procedure. Use new "O" ring.
scientia non olet · About LEMON Manuals