Stall Test
- Before performing test, check transaxle fluid level, bring engine to normal operating temperature and attach a tachometer to engine.
- Test consists of determining engine speed obtained at full throttle in "D" (Drive) position. Both parking and service brakes should be applied while performing test.
CAUTION:
DO NOT
hold throttle open any longer than is necessary to obtain a maximum engine speed reading, and never longer than 5 seconds at a time.
- If more than one stall test is required, operate engine at approximately 1000 RPM in Neutral for 20 seconds, to allow transaxle fluid to cool between tests. If engine speed exceeds maximum limits shown, release accelerator immediately since transaxle clutch slippage is indicated.
STALL SPEED SPECIFICATIONS
| Engine |
Transaxle Model |
Stall Speed RPM |
| 2.2L |
| Carbureted |
A-413 |
2620-2820 |
| EFI |
A-413 |
2210-2410 |
| Turbo |
A-413 |
3150-3350 |
| 2.5L |
A-413 |
2250-2450 |
| 2.6L |
A-470 |
2450-2650 |