Low-Reverse Band (Rear)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1984 Plymouth Turismo, 1984 Plymouth Reliant, 1984 Plymouth Horizon, 1984 Dodge Rampage, and 1984 Dodge Omni. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Low-Reverse band adjusting screw is located on rear servo lever. Transmission oil pan must be removed to provide access to band adjusting screw.

Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location

Drain transaxle fluid and remove oil pan. Pressurize low-reverse servo with 30 psi air and measure gap between band ends. If less than .080" (2.0 mm), band has excess wear and should be replaced.

To adjust A-413 and A-470 models, loosen lock nut approximately 5 turns and tighten adjusting screw to 41 INCH lbs. (4.6 N.m). Back off adjusting screw specified number of turns given in table, hold in this position and tighten lock nut.

NOTE: A-415 low-reverse band is not adjustable.

LOW-REVERSE BAND ADJUSTMENT

Application	Back Off Screw
A-413 & A-470	3 1/2 Turns