Installation Procedure
Connect the electrical connector.
- Communication Interface Module Battery (2) - Install
- Install the communication interface module battery cover (1).
Communication Interface Module (1) - Install
- Ensure that the retaining tabs are fully secured.
- Connect the electrical connector.
Headlining Trim Panel (1) - Install
Body Rear Corner Upper Garnish Molding - Right Side (3) - Install
- Body Rear Corner Upper Garnish Molding Bolt - Right Side (2) - Install and tighten - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap - Right Side (1) - Install
- Perform the necessary programming and setup procedure:Control Module References
CAUTION:
Refer to Fastener Caution .