Removal Procedure
- Rear Suspension Cradle - Remove - Rear Suspension Cradle Removal and Installation (FE2) , or Rear Suspension Cradle Removal and Installation (F47)
Retainer (1) - Remove [2x]
- Electrical Connector (2) - Disconnect
- Auxiliary Battery Positive Cable Nut (3) - Remove
- Battery Positive and Negative Cable (4) - Reposition
- Drive Motor Battery Charger Inlet Hose Clip Bolt (5) - Remove
- Retainer (6) - Disengage [2x]
- Drive Motor Power Distribution Control Module Hose (7) - Disconnect
- Drive Motor Power Distribution Control Module Hose (8) - Disconnect
Drive Motor Power Distribution Control Module Positive and Negative Cable Channel Bolt (1) - Remove [3x]
- High Voltage Electrical Connector (2) - Disconnect [4x] - High Voltage Connectors
- Drive Motor Power Distribution Control Module Positive and Negative Cable (3) - Reposition
Retainer (1) - Disengage
- High Voltage Battery Coolant Inlet Secondary Hose Nut (2) - Remove
- Rear Electric Drive Transmission Module Coolant Hose (3) - Disconnect and reposition
- Power Line Communication Module Nut (4) - Remove
- Starter Generator Negative Ground Cable (5) - Reposition
- Power Line Communication Module Nut (6) - Remove
- Starter Generator Positive Extension Cable (7) - Reposition
- Retainer (8) - Remove [3x]
Drive Motor Power Distribution Control Module Nut (1) - Remove [2x]
- Drive Motor Power Distribution Control Module Bolt (2) - Remove [2x]
- Battery Charger (3) - Remove
Chassis Rear Wiring Harness Bracket Bolt (1) - Remove
- Chassis Rear Wiring Harness Bracket Bolt (2) - Remove
- Chassis Rear Wiring Harness Bracket (3) - Remove