Installation Procedure
Install the power steering control module torque sensor wiring harness.
- Install the power steering assist motor wire clip (3).
- Install the power steering control module torque sensor wiring harness clip (2) to the electric belt drive rack and pinion steering gear housing.
- Connect the power steering control module torque sensor wiring harness (1) to the power steering assist motor.
- NOTE:
Some components not shown for graphic clarity.
Connect the power steering control module torque sensor wiring harness (1) to the electric belt drive rack and pinion steering gear.
Install the power steering assist motor wire clip (3).
- Position the power steering control module wiring power harness (1) into the 2 retaining clips (2).
- Install underbody panels as necessary. Underbody Panel Component Locator
- Remove the supports and lower the vehicle.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection