Common Specs & Procedures Index
COMMON SPECS & PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Approximate Fluid Capacities | ||
| Torque | HVAC (Base) Fastener Specifications and Auto HVAC Fastener Specifications | ||
| Wheel Drive Shaft Nut | First Pass: 150 N.m (111 lb ft) Second Pass: Loosen 45 degrees Final Pass: 250 N.m (185 lb ft) |
||
| Battery | 12 V Battery Usage , Charging System Test , Battery Inspection/Test , Battery Electrical Drain/Parasitic Load Test | ||
| Brakes | |||
| Bleeding Sequence | LEFT REAR, LEFT FRONT, RIGHT FRONT, RIGHT REAR |
||
| Disc Brakes | |||
| Service Specifications | Disc Brake Component Specifications | ||
| Torque | Fastener Specifications | ||
| Charging | |||
| Generator | Charging System Test | ||
| Torque | Fastener Specifications | ||
| Drive Belts | |||
| Adjustment | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | See the figure under Water Pump, Air Conditioning Compressor, and Generator Belt Replacement | ||
| Engine Cooling | |||
| General Service Specifications | Specifications | ||
| Radiator Cap Pressure | Pressure Cap Testing , Radiator Surge Tank Cap Testing | ||
| Thermostat R & I | Engine Coolant Thermostat Housing Replacement | ||
| Water Pump R & I | Water Pump Replacement | ||
| Engine Mechanical | |||
| Compression | Engine Compression Test | ||
| Oil Pressure | @ 1500 RPM 100°C: 29-36 psi 200-250 kPa | ||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | First Pass - 20 N.m (15 lb ft) Second Pass - 30 N.m (22 lb ft) Final Pass - additional 70 degrees |
||
| Fuel System | |||
| Pressure Specification | Ignition ON, Scan Tool Commanded - 320-608 kPa (46-88 PSI) | ||
| Fuel Pressure Test Procedure | Circuit/System Verification | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | Fuel Tank Fuel Pump Module Replacement | ||
| Ignition | |||
| Firing Order & Cylinder Identification | Firing Order & Cylinder Identification | ||
| Ignition Wires (Resistance) | Coil On Plug | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug | |||
| See Parts Catalog for Application | |||
| Gap | 0.60-0.70 mm (0.024-0.028 in) | ||
| Torque | 17 N.m (13 lb ft) | ||
| Starting | |||
| Starter | Starter Replacement | ||
| Torque | Fastener Specifications | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specifications | ||
| Torque | Fastener Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 140 N.m (103 lb ft) For Tightening Sequence, see the figure under tire Installation Procedure |
||