LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2025 >> Equinox EV LT, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Driver Assistance Systems - Repair Instructions >> Repair Instructions >> Image Processing Module Replacement >> Installation Procedure

Installation Procedure

  1. GM6396352Courtesy of GENERAL MOTORS COMPANY

    Image Processing Module (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Active Safety Control Module Bracket Nut (1) - Install and tighten [3x] - Fastener Specifications
  3. Connect the electrical connectors.
  4. GM6358474Courtesy of GENERAL MOTORS COMPANY
  5. Quarter Lower Rear Trim Panel - Left Side (1) - Install
  6. Connect the electrical connector.
  7. GM6361078Courtesy of GENERAL MOTORS COMPANY

    Body Lock Pillar Lower Trim Panel Bolt (2) - Install and tighten - Fastener Specifications

  8. Quarter Trim Panel Cover (1) - Install
  9. GM6342064Courtesy of GENERAL MOTORS COMPANY

    Cargo Tie Down Loop (3) - Install

  10. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers
  11. Cargo Tie Down Loop Bolt (2) - Install and tighten - Fastener Specifications
  12. Cargo Tie Down Loop Bolt Cap (1) - Install
  13. GM6342034Courtesy of GENERAL MOTORS COMPANY

    Convenience Net Retainer (1) - Install and tighten - Fastener Specifications

  14. GM6361116Courtesy of GENERAL MOTORS COMPANY

    Liftgate Sill Garnish Molding (2) - Install

  15. Liftgate Lock Striker Cover (1) - Install
  16. GM6347332Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Stowage Compartment Divider (2) - Install

  17. Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Install and tighten [4x] - Fastener Specifications
  18. GM6347328Courtesy of GENERAL MOTORS COMPANY

    Load Floor Stowage Compartment Cover (1) - Install

  19. GM6341389Courtesy of GENERAL MOTORS COMPANY

    Quarter Window Trim Finish Panel (1) - Install

  20. GM6341387Courtesy of GENERAL MOTORS COMPANY

    Quarter Window Trim Finish Panel Bolt (1) - Install and tighten - Fastener Specifications

  21. Quarter Window Trim Finish Panel Bolt Cap (2) - Install
  22. GM6341385Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Shoulder Belt Guide (1) - Install

  23. GM6340823Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Sill Garnish Molding (1) - Install

  24. GM6377839Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Back Cushion - Left Side (3) - Install - Rear Seat Back Cushion Removal and Installation - Left Side

  25. Enable the SIR System. SIR Disabling and Enabling
  26. Perform the necessary programming and setup procedure:Control Module References .
scientia non olet · About LEMON Manuals