Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Seat Belt Guide Adjuster (2) - Install

1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers 
4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation.

Courtesy of GENERAL MOTORS COMPANY

Front Seat Belt Guide Bolt (1) - Install and tighten - Fastener Specifications 

Courtesy of GENERAL MOTORS COMPANY

Feed the seat belt through the Center Pillar Upper Trim Panel (3).

Courtesy of GENERAL MOTORS COMPANY

If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:

1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Courtesy of GENERAL MOTORS COMPANY

Center Pillar Lower Garnish Molding Lower Hole Cover (1) - Install