LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Traverse Z71 >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Windshield Replacement >> Removal Procedure

Removal Procedure

  1. GM6389531Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Windshield Wiper Arm Finish Cap (1) - Remove

  2. GM6389532Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Windshield Wiper Arm Nut (1) - Remove

  3. Windshield Wiper Arm (2) - Remove
    4. NOTE:

    Left side shown, right side similar.

  4. GM6389378Courtesy of GENERAL MOTORS COMPANY

    Air Inlet Grille Panel Extension (1) - Remove

  5. GM6397934Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Hood Rear Outer Air Inlet Seal Retainer (1) - Remove

  6. Hood Rear Outer Air Inlet Seal (2) - Remove
  7. GM6389379Courtesy of GENERAL MOTORS COMPANY

    Air Inlet Grille Panel Retainer (1) - Remove [8x]

  8. Windshield Washer Nozzle Hose @ Windshield Washer Pump Hose - Disconnect
  9. Air Inlet Grille Panel (2) - Remove
  10. Disable the SIR system. SIR Disabling and Enabling
  11. GM5951192Courtesy of GENERAL MOTORS COMPANY

    Pull down the windshield garnish molding (1) rearwards to release the retaining clips (2) from the A pillar.

  12. Access the windshield garnish molding bolt (3) on the backside of the windshield garnish molding (1).
  13. Windshield Garnish Molding Bolt (3) - Remove
  14. GM6399543Courtesy of GENERAL MOTORS COMPANY

    Windshield Garnish Molding (1) - Remove

  15. GM6389516Courtesy of GENERAL MOTORS COMPANY

    Windshield Multifunction Sensor Mount Bracket Cover Insert (1) - Remove

  16. GM6389517Courtesy of GENERAL MOTORS COMPANY

    Windshield Multifunction Sensor Mount Bracket Cover (1) - Remove

  17. GM6389417Courtesy of GENERAL MOTORS COMPANY

    Inside Rearview Mirror Bolt (1) - Remove

  18. Inside Rearview Mirror (2) - Remove
  19. GM6398056Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector.

    20. NOTE:

    Observe the mounting and location of the front view camera to ensure proper reinstallation.

  20. Release the retaining tabs.
  21. Slide the front view camera (1) upward to release.
  22. Front View Camera (1) - Remove
  23. GM6389518Courtesy of GENERAL MOTORS COMPANY

    Disconnect all electrical connectors.

    24. WARNING:

    Refer to Eye Protection Warning .

  24. Windshield Outside Moisture / Ambient Light and Humidity Sensor (1) - Remove and DISCARD
  25. GM6398057Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT remove or service the sensor farm pins.

    Front View Driver Information Camera Bracket (1) - Remove

  26. Release the front view driver information camera bracket (1) retaining tabs and slide the bracket upward to disengage the sensor farm pins.
  27. Gently pull the front view driver information camera bracket (1) away from the windshield.
  28. GM6389519Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Keep the cutting edge of the tool against the window.

    Use J-24402 - A  Glass Sealant Remover (1) or equivalent regional tools to remove the window.

    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
  29. GM6389520Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, remove the windshield (1) and locating pin (2) from the vehicle.

scientia non olet · About LEMON Manuals