LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Traverse Z71 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Driver Assistance Systems - Repair Instructions >> Repair Instructions >> Active Safety Control Module Bracket Replacement >> Installation Procedure

Installation Procedure

  1. GM6397872Courtesy of GENERAL MOTORS COMPANY

    Active Safety Control Module Bracket (3) - Install

  2. Wiring Harness Retainer (2) - Install
    3. CAUTION:

    Refer to Fastener Caution .

  3. Active Safety Control Module Bracket Nut (1) - Install and tighten [3x] - Fastener Specifications
  4. GM6397873Courtesy of GENERAL MOTORS COMPANY

    Active Safety Control Module (2) - Install

  5. Active Safety Control Module Nut (1) - Install and tighten [3x] - Fastener Specifications
  6. Connect the electrical connectors.
  7. GM6399525Courtesy of GENERAL MOTORS COMPANY

    Quarter Lower Rear Trim Panel- Left Side (1) - Install

  8. Connect the electrical connectors.
  9. GM4755353Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel (1) - Install

  10. GM6389419Courtesy of GENERAL MOTORS COMPANY

    Liftgate Lock Striker Cover (1) - Install

  11. GM6399531Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Stowage Compartment Divider (2) - Install

  12. Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Install and tighten [4x] - Fastener Specifications
  13. GM6399529Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Panel Front Trim (1) - Install

  14. GM6399524Courtesy of GENERAL MOTORS COMPANY

    Load Floor Trim Panel (1) - Install

  15. GM6399467Courtesy of GENERAL MOTORS COMPANY

    Cargo Tie Down Loop (3) - Install [2x]

  16. Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
  17. Cargo Tie Down Loop Trim Cover (1) - Install [2x]
  18. GM6399466Courtesy of GENERAL MOTORS COMPANY

    Body Rear Corner Upper Garnish Molding (3) - Install

  19. Body Rear Corner Upper Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
  20. Body Rear Corner Upper Garnish Molding Cap (1) - Install
  21. GM6399528Courtesy of GENERAL MOTORS COMPANY

    Quarter Upper Trim Panel (3) - Install

  22. Quarter Upper Trim Panel Bolt (2) - Install and tighten - Fastener Specifications
  23. Quarter Upper Trim Panel Bolt Cap (1) - Install
  24. GM4772715Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Sill Garnish Molding (1) - Install

  25. Enable the SIR System. SIR Disabling and Enabling
  26. Perform the necessary programming and setup procedure: Control Module References
scientia non olet · About LEMON Manuals