Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Battery Hold Down Bolt | 22 N.m (16 lb ft) |
| Battery Hold Down Retainer Bolt | 9 N.m (80 lb in) |
| Battery Negative Cable Bolt @ Transfer Case | 22 N.m (16 lb ft) |
| Battery Negative Cable Ground Nut @ Front Wheel Well Extension | 9 N.m (80 lb in) |
| Battery Negative Cable Nut @ Battery Sensor | 11 N.m (97 lb in) |
| Battery Negative Post Clamp Nut | 4.5 N.m (40 lb in) |
| Battery Positive and Negative Cable Conduit Bolt | 9 N.m (80 lb in) |
| Battery Positive Cable Nut @ Starter Solenoid | 12.5 N.m (111 lb in) |
| Battery Positive Post Clamp Nut | 9 N.m (80 lb in) |
| Battery Tray Mounting Bolt | 22 N.m (16 lb ft) |
| Engine Wiring Harness Junction Block Nut | 16 N.m (12 lb ft) |
| Generator Fastener | 15 N.m (11 lb ft) |
| Generator Mounting Nut | 58 N.m (43 lb ft) |
| Generator Mounting Stud | 9 N.m (80 lb in) |
| Starter Heat Shield Fastener | 9 N.m (80 lb in) |
| Starter Mounting Bolt | 58 N.m (43 lb ft) |