Removal Procedure

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the left and right steering wheel airbag access hole covers (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Airbag Bolt(1) - Remove[2x]
Courtesy of GENERAL MOTORS COMPANY

Use a flat bladed plastic trim tool to separate the steering wheel airbag plate (1) from the steering wheel horn plate (2).
Courtesy of GENERAL MOTORS COMPANY

Pull the steering wheel airbag away from the steering wheel to expose the electrical connections.
Disconnect the electrical connector.
Steering Wheel Airbag(1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Loosen the steering wheel bolt (1) so that 2-3 threads are engaged.
Wiggle the steering wheel until the wheel disengages completely.
Steering Wheel Bolt(1) - Remove
Disconnect the electrical connector.
Steering Wheel(2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Cruise Control Switch Bolt (1) - Remove[2x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt(1) - Remove
Disconnect the electrical connectors and reposition the wiring harness as necessary.(2)
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt(1) - Remove[2x]
Disconnect the electrical connector.
Steering Wheel Trim Spoke Cover Applique (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Steering Wheel Spoke Cover Bolt- Left Side and Right Side(2) - Remove[4x]
Automatic Transmission Manual Shift Auxiliary Position Switch- Left Side and Right Side(3) - Reposition[2x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt(2) - Remove[2x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt(1) - Remove[5x]
Steering Wheel Shroud(2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Heated Steering Wheel Module (1) - Remove