Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Pull rearward to clear the tab and remove the instrument panel outer trim cover (1).
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster Bolt (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

WARNING:
When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

Instrument Panel Knee Bolster (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Open the instrument panel compartment door.
Disconnect the instrument panel compartment door dampener (2) from the instrument panel compartment door (1).
Push the sides of the instrument panel compartment door (1) to allow the door to open past the stops.
Courtesy of GENERAL MOTORS COMPANY

Unsnap the instrument panel compartment door (1) from the instrument panel assembly.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Remove [7x]
Instrument Panel Compartment Door Opening Frame (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console (1) - Remove - Front Floor Console Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Trim Accent Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Heater and Air Conditioning User Interface Control Bolt (1) - Remove [2x]
Heater and Air Conditioning User Interface Control (2) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Bolt (1) - Remove [4x]
Instrument Panel Lower Center Trim Panel (2) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Release the retaining tab.
Ignition and Start Switch (1) - Remove