Removal Procedure

WARNING: This page is about a different car, the 2023 Chevrolet Silverado 1500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

WARNING:
When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Knee Bolster (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Starting from the rear, use a plastic trim tool to release the retainers securing the front floor console applique (1) on both sides of the front floor console.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Pull the front floor console applique (1) rearward to clear the integral tabs out on both sides of the instrument panel lower trim panel.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Open the instrument panel compartment door for better access to the retaining clips.

Instrument Panel Lower Trim Panel Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Trim Panel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use a plastic trim tool if necessary.

Pull away from the front side door weatherstrip to remove the instrument panel fuse block access hole cover (1).
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Outer Filler Bolt (1) - Remove [2x]

NOTE:

Use a plastic trim tool if necessary.

Instrument Panel Lower Trim Panel Outer Filler (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Center Trim Panel Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Center Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Unclip the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.
Disconnect the electrical connector for the driver monitoring camera.
Instrument Panel Steering Column Upper Trim Cover (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Cluster Trim Plate Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Disconnect the electrical connector.
Instrument Panel Cluster Trim Plate (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Steering Column Upper Trim Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Driver Monitoring Camera (1) - Remove