LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Driver Assistance Systems) >> Diagnostic Information and Procedures >> Forward Collision Alert System Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2023 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

WithoutUV6

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following component/system:
    • Forward Collision Alert
    • Go to next step: If no DTC is set
  3. Verify the following component is properly installed: B174W Frontview Camera - Windshield
    • If the component is not properly installed 

      Repair as necessary

    • Go to next step: If the component is properly installed 
  4. Verify the condition does not exist: B174W Frontview Camera - Windshield - Dirty or Blocked by debris
    • If the condition exists 

      Clean the components as necessary.

    • Go to next step: If no condition exists 
  5. Using the Steering Wheel Controls Switch - Left

    Verify the display changes mode = Far/Medium/Near/OFF - The value should change when selecting the different modes.

    • If not the specified values 

      Refer to: Circuit/System Testing - Test 1

    • Go to next step: If the specified values 
  6. Perform the appropriate scan tool control function: All Indicators

    Verify the component activates: Collision Alert - Indicators

    • If the component does not work as specified 

      Refer to: Circuit/System Testing - Test 2

    • Go to next step: If the component works as specified 
  7. All OK.

WithUV6

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following component/system:
    • Forward Collision Alert
    • Go to next step: If no DTC is set
  3. Verify the following component is properly installed: B174W Frontview Camera - Windshield
    • If the component is not properly installed 

      Repair as necessary

    • Go to next step: If the component is properly installed 
  4. Verify the condition does not exist: B174W Frontview Camera - Windshield - Dirty or Blocked by debris
    • If the condition exists 

      Clean the components as necessary.

    • Go to next step: If no condition exists 
  5. Using the Steering Wheel Controls Switch - Left

    Verify the display changes mode = Far/Medium/Near/OFF - The value should change when selecting the different modes.

    • If not the specified values 

      Refer to: Circuit/System Testing - Test 1

    • Go to next step: If the specified values 
  6. All OK.
scientia non olet · About LEMON Manuals