Single Use Fasteners and Components

Steering Gear Boot Clamp

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Front Compartment Lower Noise Shield Replacement (Coupe - LGX, LTG) Steering Linkage Outer Tie Rod Replacement
1	Steering Linkage Inner Tie Rod Nut Procedure Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.
2	Steering Gear Boot Outer Clamp
3	Steering Gear Boot Inner Clamp Procedure Cut the steering gear boot inner clamp. DISCARD the clamp. Use the DT-39510 pliers to install the NEW steering gear boot inner clamp. NOTE: Position the NEW steering gear boot inner clamp on the steering gear boot before installing the boot on the steering gear. Special Tools DT-35910 Drive Axle Boot Clamp Pliers Equivalent regional tools:Special Tools
4	Steering Gear Boot Procedure After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination.If corrosion or contamination is evident, replace the steering gear. Electric Belt Drive Rack and Pinion Steering Gear Replacement (LGX, LTG) , or Electric Belt Drive Rack and Pinion Steering Gear Replacement (LT1, LT4 or LTG with 1LE) Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.