Removal Procedure
- Remove the spare tire and wheel assembly.
- Using the scan tool, deflate the automatic level control air supply reservoir
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Electrical Connector (2) - Remove
- Remove the 7 automatic level control air compressor tube fitting (1) from the air suspension controller.
Remove the 2 automatic level control solenoid bolts (1).
Remove the air suspension controller (1) and air suspension control module as an assembly.
Automatic Level Control Air Compressor Bolt (1) - Remove [2x]
- Air Suspension Control Module (3) - Remove
NOTE:
Service mode will be automatically enabled when the ride height sensors detect the vehicle has been lifted off the ground. Service mode will automatically be disabled when the vehicle reaches 16 km/h (10 MPH).