Removal Procedure
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Seat Riser Finish Cover-Passenger Side (1) - Remove
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clip.
- Rear Seat Riser Finish Cover-Passenger Side (1) - Remove [2x]
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Using a suitable plastic trim tool, release the retaining tabs.
- Remove the passenger side outboard rear seat riser inner finish cover (1).
- NOTE:
Left side shown, right side similar.
If necessary, reposition the rear seats to access the passenger side inboard rear seat riser inner finish cover (1)
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Using a suitable plastic trim tool, release the retaining tabs.
- Remove the passenger side inboard rear seat riser inner finish cover (1).
- NOTE:
Left side shown, right side similar.
Rear Seat Riser Finish Cover Retainer-Passenger Side (1) - Remove [2x]
- Release the J-channel retainers from the passenger side rear seat cushion cover and rear seat cushion trim panel (2).
- NOTE:
Left side shown, right side similar.
Release the remaining J-channel retainers on the passenger side rear seat cushion trim panel (2).
- Rear Seat Back Opening Finish Cover Retainer-Passenger Side (1) - Remove [4x]
- NOTE:
Left side shown, right side similar.
Place the rear seat in the fold and tumble position.
- Rear Seat Cushion Trim Panel-Passenger Side (1) - Remove
Disconnect the electrical connectors.
- Front Seat Bolt (1) - Remove
- Release the rear seat heater vent control module retaining tabs.
- Rear Seat Heater Vent Control Module (2) - Remove